Tape-Ease™ Directions for use:

1. After choosing either the pipe model, or the edge-gripping model (with the rubber), extend a few inches of the tape measure.	2. Place the curve of the tape measure's blade between the 2 rails of the Tape-Ease, making sure that both edges of the tape blade are secured.	3. Release the gentle hold on the tape measure's blade so that it engages under the "rails" of the device.	4. Place a couple of fingers under the vertical section, then slide the unit up to the end of the tape measure.	5. Make sure the hook-end of the tape measure is seated securely.
* To remove, slide down a few inches, and gently pinch and snap it off.

Tape-Ease™ Model for Gripping Edges	Tape-Ease™ Model for Measuring Pipe/PVC/Conduit
Attachment to Surface (Making sure slight pressure is applied throughout pull.) Full Extension of Tape-Ease™, with room to go! It even grips on bullnose and corners!	Tape-Ease™ Pipe Model Engaged in various sizes of pipe (Will work from 1/2 inch diameter pipe up to 6 inch+ diameter conduit.) Insert the Tape-Ease™ into the pipe, and pull the measure to the desired length.
Tape-Ease™ is currently manufactured and available in the two most common industrial sizes for tape measures (1 inch and 1.25 inch widths).

TapeEase™ in Action

TE-12 on an Adobe Wall!

TE-11 on a T-post Fence!